Working with FTB/FGR series
6-digit LED display
Flow rate/total flow display
1 pulse counting input
1 relay (REL) output
24V DC power supply output
RS-485 / Modbus RTU
Specification Table
Order No
| Supply voltage | 19...50Vdc,16...35Vac or 85...260Vac/Vdc |
| Power consumption | Max. 4.5VA |
| Show | Redled, high6x9mm |
| Display value range | 0...999999 +decimal point |
| Instantaneous flow reading accuracy | Choose0.0.00000unit |
| Flow accuracy | ± 1 arrive± 0.0001optional |
| Enter | |
| Potential isolation of pulses by corresponding vibration damping, input frequencyMax. 10.0 kHz; | |
| Cumulative reset: active edge or active level, galvanically isolated | |
| Cumulative capacity | More than the4x109 m3 (max. 15effective number) |
| Display unit | |
| Instantaneous flow | L orm3 /seconds, minutes, hours |
| Accumulation | L orm3 |
| Pulse wait width | 0.1.39.9seconds can be set |
| Output type | |
| Relay output | Imax =1A,umax=250Vac (cosΦ=1) |
| Sensor power output | 24Vdc +5%/-10%, Max. 100 mA (Regulated voltage, no need to isolate from communication interface) |
| Communication Interface | RS-485,8N1and8N2,1200...115200 bit/s; |
| Modbus RTU(without galvanic isolation) | |
| Operating temperature | 0...+50°C |
| Degree of protection | IP65(Add protective film to the display panel);IP20(Housing and connection clip) |
| Meter size (longxWidthxhigh) | 72 x 36 x 97mm |
| Installation depth | Min. 102mm |
| Plate thickness | Max. 5mm |
